If you really wish to overwrite the old port of tailscale You may wish to make deinstall'' and install this port again by make reinstall'' to upgrade it properly. => An older version of tailscale is already installed (tailscale-1.0.3) Updated my 1.0.3 to 1.2.0 without errors seen by # make install clean Tailscale = 1.0.3 installed like i described it before Opnsense = OPNsense 20.7.4-amd64 | FreeBSD 12.1-RELEASE-p10-HBSD | OpenSSL 1.1.1h | on old sophos SG210 VDSL = german telekom -> Draytek 130 Modem -> UDM Pro -> opnsense With this setting i'm able to get access from my phone via LTE to the webportal of the opnsense inside a NATed network IPv4 TCP/UDP | NET_tailscale | * | This Firewall | * | Null4 | * | tailscale

Protocol | Source | Port | Destination | Port | Gateway | Schedule | Description NET_tailscale | Network(s) | tailscale Network | 100.0.0.0/8 I used an alias for definig the tailscale network: I tried several - trying to make the tailscale interface schowing up in opnsense GUI but every time the whole configuration gets corruptet.įixing that requests a firwall rule inside the Floating Section passing the traffic 'inside' the tailscale network. but getting access from another TS client to the opnsense was not functional.Įvery access via the 100.x.x.x was blocked by the DefaultDenyRule. I can ping outside and also doing ssh and so. In system - routes - status all my systems are shown with gateway tailscale. Interface Assignments (but i was not able to rally assin an interface to it.), my opnsense showed up in the tailscale administration and the tailscale interface showed partly in opnsense GUI. Thanks does this show up in the GUI after making?

Tailscale opnsense